iFixRetro
@iFixRetro
Followers
15K
Following
18K
Media
7K
Statuses
20K
We love old school games and preserving it by rebuilding the hardware, making it better and funky fresh for you! video games everyday. email: [email protected]
Brooklyn, NY
Joined April 2017
If you need to message me for an inquiry and you don't have twitter blue, please send me an email at info@ifixretro.com.
5
8
73
Mainboard and PSU has been recapped to ensure that this system will continue to last in its shitty lifecycle!
0
0
3
Tired of your system crapping out because the lens no longer reads your games? No problem! With the 3DO USB ODE kit installed on the Panasonic FZ-10 console, you'll be able to play all the craptastic titles in the 3DO library using a USB media solution!
2
1
33
Stuck in a shitty situation where your system no longer reads discs and there isn't any viable working lens for them no matter how hard you tried to source them? 3DO USB ODE installed on a Panasonic FZ-1 3DO console! Access your library using a USB based media with fast loading
1
3
41
Removing the ram and cleaning up the pads. When I first tested the 4 slot out, I was planning to just bypass the ram error with a 3.2 Unibios, but it kept freezing after a minute or two of gameplay, and so I decided to remove both upper and lower ram and replace them and it fired
1
1
5
Chonky ass 4 slot Neo Geo MVS board saved and 3.2 Unibios hooked up on the arcade system! The MVS wouldn't start up properly due to a work ram error, so I replaced both the upper and lower ram and it booted up properly again and loaded the games successfully!
1
5
63
Replaced the capacitors on the Namco System 11 board and cleaned the hell out of the sound pot, since it was outputting in very low volume.
0
0
8
Reflowed both Sony chips and realigned the legs back to the pad, since it was lifted off from the board due to age.
2
0
10
Soul Edge Ver. 2 board repaired back in working order and sound volume restored as well! At first the Namco System 11 board wasn't booting up, due to the fine pitched legs being lifted off and bent away from the board, so I aligned the legs back in its original spot and reflowed
2
1
22
Reflowing the SCU and SH-2 chips. These are the main culprits that causes the system to not boot up, due to the board flexing and causing the legs to lift off the board.
1
2
10
Sega Titan Video (ST-V) arcade system board repaired and restored back in working order and Multibios hooked up! The system was displaying a black screen on boot, and if it did work, it was displaying a garbled image. Since this arcade board is known to be really fragile in
1
7
74
Mounting the capture card, and filing the port for it. What a tedious process to do.
0
1
19
Loopy Video Capture card installed on the original Nintendo DS handheld system! Play your DS/GBA games on the PC monitor using the USB C port as it charges simultaneously at the same time, with barely minimal input lag on it. You can also configure the video settings to your
6
16
169
More installation of the Shiny Gem kit, removing a previously modded Modbo, due to conflict with MemcardPro
1
1
8
Shiny Retro Gem HDMI kit installed on a white Sony PlayStation 2 console! Play your games in crispy ass 1080/1440p HD display on a flat screen and it features an OSD menu that allows you to customize your video options, such as scanlines, scaling and more! System has been
1
3
53