IF you have a signal sleuth with a battery board, we finally figured out the switch needs to be up towards the antennas for it to have low voltage protection. Down will allow it to fully discharge the batteries, which will damage them. Thanks to @pejacoby for finding this.

Don't like it but it'll do untill I can design one.

Need to design a case but I don't have time right now lol

If your in the Dallas area don't miss @BSidesDFW can't wait! https://t.co/tIlGk8Lvzz

I think it's time to rebuild

Just restocked some kits!

Finished my 65mm so small next to the 75mm #tinywhoop #fpv

Finally assembled the mesh detect @_colonel_panic sent me.. now just to flash it and then I need to order the oui spy.

Code is by MidwestGadgets but finally making this @HackerBoxes show me some more info. Had to rewire the esp32 because using gpio4 messes up wifi use. #homelab

Doing some organizing.

AntiHunter Prototype V2 assembly test

Forgot I had these

Alright one more for matching hardware 😎

Got the new case installed and got the RGB backlight installed. So happy with how it turned out.

Burning the midnight oil 💻 Another late night in the shop to kick off the week 🫠 Stacking jobs wherever I can and squeezing every last bit of productivity out of the day. My https://t.co/UGZ6NrKTkF device from @463n7_57, decided to throw me a curveball during a firmware

New case for my flipper... Guess I need to finally install the RGB back light too

Now I can dry while I print!

Really need to get my drone detector built by @_colonel_panic so I can play around with it when I fly

Packing some Christmas trees

Added a cooler to this little pi... Still not sure what I'm going to do with it